![]() Easy and dependable way to install Perl modules. There apt or yum or similar command for your flavour of linux are available. Use WSL - windows subsystem for linux.The latter is perhaps easiest available through use the CPAN command from 5.28, but for many if not most modules you need make or dmake.Perl 5.26 where PPM a is still available I think, find it at.In my test on Windows 10 the Switch module was installed without trouble like this. This installation file includes ActivePerl 5.28 and the modules you picked. Note: I found I needed to add some cr/lf to the text, otherwise I would get a error message about code not being formated correctly.Īccording to ActivePerl 5.28 has removed the old PPM interactive GUI module installation tool in favor of the new website where you log in, pick modules, builds, waits and finally downloads your own custom runtime as one big. That had no effect, if there are files in the directories they are updated Giving up parsing your C:\Perl64\cpan\sources\modules\, too many errorsLockfile removed.Ĭ:\Perl64\cpan\sources\authors and C:\Perl64\cpan\sources\modules\ ![]() I'll continue but problems seem likely to happen. Giving up parsing your C:\Perl64\cpan\sources\modules\, too many errorsReading 'C:\Perl64\cpan\sources\authors\' Could not split lineĬould not split line Warning: Your C:\Perl64\cpan\sources\modules\ does not contain a Last-Updated header. I'll continue but problems seem likely to Please check the validity of the index file by comparing it to more Warning: Your C:\Perl64\cpan\sources\modules\ does not contain a Line-Count header. Use of uninitialized value $command in concatenation (.) or string at C:\Perl64\lib/CPAN/Tarzip.pm line 163. Reading 'C:\Perl64\cpan\sources\modules\' '-qdt' is not recognized as an internal or external command, Use of uninitialized value $command in concatenation (.) or string at C:\Perl64\lib/CPAN/Tarzip.pm line 163, line 1. Reading 'C:\Perl64\cpan\sources\authors\' Log::Log4perl recommended for better loggingĬpan shell - CPAN exploration and modules installation (v2.20) I started cpan and then did install Switch.pm When I try to run it I get: Can't locate Switch.pm in (you may need to install the Switch module) contains: C:\Perl\lib C:/Perl64/site/lib C:/Perl64/lib) at fds_propagator_with_collision_ line 108. It currently runs on windows 7 with Active Perl 5.8.8. I'm trying to get a Perl script running on Windows 10 with Active Perl 5.28.1.
0 Comments
Leave a Reply. |